SECURE AND HOLD DOWN SHEAR WALLS TO THE STRUCTURE FOUNDATION
ClarkDietrich holdowns provide cost-effective shearwall attachment and are used to transfer tension loads between floors or from structural members to the foundation.
Two-piece welded construction comes in three sizes for optimal performance. Installation is made easy with prepunched holes.
Material: 7 Gauge (179mil) with 1/2" bearing plate
ASTM: A36, A1011
Anchor hole size: 7/8" x 1-1/8"
PRODUCT DATA & ORDERING INFORMATION
| Product code | Gauge | Mils | Design thickness (in) | Size (in) | Packaging |
|---|---|---|---|---|---|
| CD8-B | 7 | 179 | 0.188 | 2-5/8 x 11 | Dependent on Order Quantity |
INSTALLATION:
- Install the holdowns using anchor bolts or alternate anchorage calculated to resist the tension load for your specific application.
- Use steel nylon locking nuts or thread adhesive to minimize the chance of nut spin. Anchor bolt washer is not required.
- For the bolted holdowns, secure the CD holdown to the steel framing member with 3/4" and 1/2" diameter bolts in the prepunched holes per the design load table to achieve listed capacities. Field drill holes in the framing member as required to accomodate the required bolts.
- Boundary members (back-to-back studs) shall be designed by a qualified professional. To tie back-to-back stud members together, the Designer must determine the fasteners required to bind members to act as one unit.
- CD holdowns can be welded per Designer's recommendation and specification.
- Welding procedures shall be qualified as specified in AWS D1.3.
- Welded connections used for cold-formed steel structural members in which the thickness of the thinnest connected part is 0.18 inch or less shall comply to AISI S100-2012 specification Section E2.
Reference section R603.9.4.2 of the International Residential Code (IRC) for holdown requirements in residential applications. Consult the engineer of record for commercial applications.